Opened 14 years ago
Last modified 8 years ago
#5474 closed defect
Keyspan USA-19QW on host Ubuntu Karmic 9.10 64-bit guest XP — at Initial Version
Reported by: | ajoliveira | Owned by: | |
---|---|---|---|
Component: | USB | Version: | VirtualBox 3.0.10 |
Keywords: | keyspan USA-19QW | Cc: | |
Guest type: | Windows | Host type: | Linux |
Description
Hello
Mentioned USB hardware was working on a XP guest on vb 3.08 in Jaunty 9.04 64-bit (well, had to disable and enable it again, but it worked). After upgrading to 9.10, blue screen every time I want to use it and XP crash when I click at the bottom status bar to select it. Upgraded vb to 3.10, same result, device unusable.
lets check dmsg output:
it stated on 9.04:
[34923.500028] usb 2-2: new full speed USB device using uhci_hcd and address 2 [34923.654165] usb 2-2: configuration #1 chosen from 1 choice [34924.499312] usbcore: registered new interface driver usbserial [34924.499335] USB Serial support registered for generic [34924.499374] usbcore: registered new interface driver usbserial_generic [34924.499377] usbserial: USB Serial Driver core [34924.505696] USB Serial support registered for Keyspan - (without firmware) [34924.505718] USB Serial support registered for Keyspan 1 port adapter [34924.505737] USB Serial support registered for Keyspan 2 port adapter [34924.505758] USB Serial support registered for Keyspan 4 port adapter [34924.505787] keyspan 2-2:1.0: Keyspan - (without firmware) converter detected [34924.505794] usb 2-2: firmware: requesting keyspan/usa19qw.fw [34924.598338] usb 2-2: Required keyspan firmware image (keyspan/usa19qw.fw) unavailable. [34924.598373] usbcore: registered new interface driver keyspan [34924.598377] keyspan: v1.1.5:Keyspan USB to Serial Converter Driver
usa19qw.fw was proprietary firmware, hence not available
and now on 9.10:
[24074.182589] usb 3-3: new full speed USB device using ohci_hcd and address 5 [24074.402313] usb 3-3: configuration #1 chosen from 1 choice [24074.405250] keyspan 3-3:1.0: Keyspan - (without firmware) converter detected [24074.405267] usb 3-3: firmware: using built-in firmware keyspan/usa19qw.fw [24074.938396] usb 3-3: USB disconnect, address 5 [24074.938479] keyspan 3-3:1.0: device disconnected [24076.062566] usb 3-3: new full speed USB device using ohci_hcd and address 6 [24076.294283] usb 3-3: configuration #1 chosen from 2 choices [24076.297964] keyspan 3-3:1.0: Keyspan 1 port adapter converter detected [24076.298193] usb 3-3: Keyspan 1 port adapter converter now attached to ttyUSB0
so device is attached to ttySB0
that is the difference I can spot. I have never used this adapter on ubuntu, only on the guest.
cheers
Antonio