Index: /trunk/src/VBox/ValidationKit/vms/t-nt310.txt
===================================================================
--- /trunk/src/VBox/ValidationKit/vms/t-nt310.txt	(revision 70488)
+++ /trunk/src/VBox/ValidationKit/vms/t-nt310.txt	(revision 70489)
@@ -6,10 +6,7 @@
  - Configure a VM t-nt310 with using the Windows NT 3.x settings, but with only
    64 MiB RAM (can't detect more) and 512 MiB disk (2GiB fails NTFS conversion).
- - Edit the storage settings:
-        1. Remove ATAPI CDROM.
-        2. Add a BusLogic SCSI controller.
-        3. Add CDROM to the SCSI controller.
  - Enable COM1.
  - Make sure networking is NAT and PCNET.
+ - Make sure you're using BusLogic for both HD and DVD-ROM.
  - Enable DNS proxying:
         VBoxManage modifyvm t-nt310 --natdnsproxy1 on.
@@ -20,12 +17,11 @@
           net and install via floppy when it fails to detect NICs.
         - Use 'password' as Administrator password.
- - Once done rebooting after installation open the network settings and
-   add the TCPIP protocol.  Configure it with IP 10.0.2.15, gateway 10.0.2.2,
-   and DNS 10.0.2.3 (via "Connections..." button).
- - Reboot and check that you can ping stuff.
- - Add regular user 'test' without a password.
  - Open the system settings and add an environment variable "SystemDrive" with the
    value "C:" (NT 3.50 and later sets this automagically).
  - while in the system settings, reduce the boot wait to 1 second.
+ - Open the network settings and add the TCPIP protocol.  Configure it with IP
+   10.0.2.15/24, gateway 10.0.2.2, and DNS 10.0.2.3 (via "Connections..." button).
+ - Reboot and check that you can ping stuff.
+ - Add regular user 'test' without a password.
  - Insert the ValidationKit ISO and install the test execution service, see
    vboxtxs-readme.txt for details.  Heed the NT 3.x bits.