Index: /trunk/doc/ReadMe-Solaris.txt
===================================================================
--- /trunk/doc/ReadMe-Solaris.txt	(revision 16037)
+++ /trunk/doc/ReadMe-Solaris.txt	(revision 16038)
@@ -18,11 +18,4 @@
 -----------
 
-* Important Note:
-You must boot OpenSolaris in the same instruction set as the VirtualBox install package.
-This means if you are installing the 64-bit version of VirtualBox you MUST boot in
-64-bit mode. This is because the installer will setup the VirtualBox driver. Use the command
-"isainfo -k" to check what instruction set is currently being used. If the output is "amd64"
-you have booted in 64-bit mode, otherwise it is 32-bit.
-
 After extracting the contents of the tar.gz file perform the following steps:
 
@@ -30,8 +23,7 @@
 
 2. Install the packages (in this order):
-    Newer versions of OpenSolaris may contain a vbi module. If your version does NOT have the
-    vbi module already installed (check for existence of /platform/i86pc/kernel/misc/vbi)
-    then run:
 
+   (*) First, the VirtualBox kernel interface package:
+   
         pkgadd -G -d VirtualBoxKern-@VBOX_VERSION_STRING@-SunOS-r@VBOX_SVN_REV@.pkg
 
@@ -39,7 +31,7 @@
         "-n -a autoresponse SUNWvboxkern" (without quotes) to the end of the above pkgadd command.
 
-     Once the vbi module is installed run:
+   (*) Next, the main VirtualBox package:
 
-        pkgadd -d VirtualBox-@VBOX_VERSION_STRING@-SunOS-@BUILD_TARGET_ARCH@-r@VBOX_SVN_REV@.pkg
+        pkgadd -d VirtualBox-@VBOX_VERSION_STRING@-SunOS-r@VBOX_SVN_REV@.pkg
 
         To perform an unattended (non-interactive) installation of this package add